1. Position the marker and clip on the locking sleeve. Drive in the anchorage using the driving tool and the hammer.
2. Stop driving when the handle of the tool is 1 cm from the marker head  (with the locking sleeve in position in the marker head).
3. Replace the driving tool with the sleeve.
4. Hit the sleeve with the hammer. This operation has the following effect: a) it drives the anchorage fully home; b) it applies high pressure, ensuring a perfect seating for the maker in the ground; c) it causes the extension of the three high-strength prongs which will firmly anchor and lock the marker.
5. Stop driving when the sleeve handle is a few centimetres from the marker head.
6. Withdraw the sleeve (reusable).

for 350,500 and 600 anchorages (re-usable)

350mm ref: 130-47
500mm ref: 228-47
600mm ref: 328-47

The Sleeve

for 350,500 and 600 anchorages (re-usable)

350mm ref: 20 350-47
500mm ref: 20 510-47
600mm ref: 20 610-47

ref: 1500-47